Abstract
A Novel Stability Indicating Rp-Uplc-Dad Method for Determination of Metformin and Empagliflozin in Bulk and Tablet Dosage Form
Nenavath Padmaja1 and Guttena Veerabhadram2
DOI : http://dx.doi.org/10.13005/ojc/330441
Abstract:
The objective of the present work was to develop and validate a novel stability indicating RP-UPLC-DAD method for the simultaneous analysis of Metformin and Empagliflozin in bulk and tablet dosage form. This new RP-UPLC method has superior in technology to formal Reverse phase-HPLC with retention time, solvent utilization, resolution and less cost. The peak area separation was accomplished on a Waters model UPLC system equipped with PDA detector and autosampler. A volume of 5 µL of sample and standard were injected into the column and all analytes were separated by using the mobile phase contains mixture 0.1% ortho phosphoric acid buffer (the pH was adjusted to 3.4 with 0.1 N NaOH) and methanol in the ratio 40:60% v/v at a flow rate of 0.25ml/min through C18 BEH(Ethylene Bridged Hybrid) UPLC (100mm x 2.1mm ,1.8µm) at 350C column temperature and the detector wavelength was set at 254 nm. The system suitable parameters such as tailing factor , resolution and plate count of two drugs were 1.16 , 1.37 ;3.47 ;2314.34 and 4723 respectively. Retention time and peak area and of Metformin and Empagliflozin were found to be 0.882 & 3.471, 4887835 &163463 respectively. Regression equation shows an r value (correlation coefficient) of greater than 0.999 for Metformin and Empagliflozin. Percent recovery of Metformin and Empagliflozin was found to be 99.92%-100.12% & 100.12%-100.56% respectively .Both Metformin and Empagliflozin were subjected to stress conditions such as acidic, basic, oxidative, thermal and photo degradation butsubstantial degradation was observed in acid studies. The newly developed RP-UPLC-DAD chromatographicmethod was validated with regard of system suitability, linearity, robustness, accuracy, LOD,precision and LOQ.
Keywords:Empagliflozin; Metformin; RP-UPLC; Stressstudies; Validation
Back to TOC